7
8
5. Adjust the steam adjustment knob to desired setting.
6. Gently pass the Garry™ Steam Mop over the area to be steamed.
7.
When the Garry™ Steam Mop stops emitting steam, simply refill
the tank and continue cleaning.
Cleaning floors
1. Fully vacuum or
sweep floors prior
to using the Garry™
Steam Mop.
2. Install the mop
pad on the swivel
head by fitting the
pad over the head
and tighten the
drawstring with the
pad tightening clamp.
See figure 3.
3. Unscrew the water tank lid and
fill the water tank using the water refill cup.
4. Release the cord by twisting the quick release cord hook and
removing the cord.
5. Plug the unit into an approved outlet as outlined previously. When
the indicator light turns from red to green, the Garry™ Steam Mop
is ready for use; usually within 30 seconds.
6. Adjust the steam adjustment knob to desired setting.
7.
To sanitize an area of your floor, place the Garry™ Steam Mop on
the area for a minimum of 5 seconds but no longer than 15 seconds.
8.
When the Garry™ Steam Mop stops emitting steam, simply refill
the tank and continue cleaning.
nOte:
To order more replacement mop pads, please refer to page 9 for
our customer service contact information.
waRnInG:
Do not leave the mop on one spot for more than 15 seconds.
Doing so could cause damage to the surface.
MaIntenance
please read all instructions and warnings before any
maintenance is performed.
1. Turn the steam adjustment knob
from Open to Close to shut off the
steam.
See figure 4.
2. Unplug the power cord from the
outlet.
3. Carefully remove the mop pad (if
used) from the swivel head. Use
caution as the mop head and pad will
still be hot.
4. Empty any remaining water from the
water tank before storing.
5. Machine wash the soiled mop pad
and tumble dry.
6. Wrap the power cord around the
upper and lower cord hooks.
7. To clean the Garry™ Steam Mop,
wipe down all outer surfaces with a
soft cloth.
8. Store the unit in the upright position
in a protected, dry area or hang by the
handle.
tROUBleSHOOtInG
If you experience problems with your Garry™ Steam Mop, please
review the following before contacting customer support. If you still
require further assistance, please refer to the LIMITED WARRANTY
near the end of this manual for Customer Support contact information.
problem: Reduced steam/no steam is coming out
Try the following:
• Make sure the water tank is filled
•
Verify the unit is plugged into an approved electrical outlet and that
the fuse or breaker is functioning properly.
•
Check that the steam adjustment knob is set to “open”.
problem: Indicator light is not working
figure 4
figure 3