CLEANING & MAINTENANCE
Cleaning the Pre-Filter
1. Release the air inlet grill by pressing on the
locking latch.
2. Gently remove the pre-filter from the air inlet grill.
3. To clean the pre-filter, simply submerge in warm
soapy water. Gently lift and submerge the
pre-filter several times until it is clean.
4. Rinse the pre-filter with clean water and allow it
to dry completely before placing it back to the
air inlet grill.
Cleaning External Surfaces
1. Turn off and unplug unit.
2. Use a washcloth slightly dampened with
a little water and dishwashing soap
to wipe the outer case surfaces.
3. Do not allow water to slip into the internal parts
as this could damage your unit and result in
electrical shock and injury to you.
4. Allow the unit to thoroughly dry before use.
UV Lamp
The lifetime of the UV lamp is up to 12 months of
continuous, effective operation. After this time, the
bulb may remain illuminated, but its effectiveness is
greatly reduced.
For maximum effectiveness,
please replace the UV bulb annually.
If the lamp stops functioning or needs
replacement, please visit our web site
at envionproducts.com to order a
replacement lamp. Or call 1.800.875.8577.
Caution:
• Do not touch the glass part of the lamp. Oil
from fingertips will decrease the effectiveness
of the lamp.
• Never operate the unit without a filter or with
a damaged filter. UV lamp cover must be
installed at all times. The UV light from the UV
lamp will result in severe damage to eyes and
could cause blindness.
UV Lamp Notice Warning:
UV Light is harmful to bare skin and eyes and can
cause temporary or cleanable loss of vision.
Never look directly at the UV lamp while it is
illuminated-doing so could cause loss of vision!
TPP
630
Before replacing the UV lamp, make sure the Therapure
®
630 air purifier is turned
off and unplugged. Let the lamp cool down for 5 minutes before replacing it.
Replacing the UV Lamp:
1. Release the inlet grill by pressing on the locking latch.
2. Grasp the left and right frames of the cleanable HEPA-Type filter through the
indentations on the sides of the filter enclosure and remove filter.
3. Remove the two bolts used to fix the UV lamp cover and remove the cover out from
the unit then unscrew the old UV lamp from the lamp base of the unit.
4. Install the new UV lamp into the lamp base of the unit.
5. Install the UV lamp cover with the two bolts on the unit.
6. Install the inlet grill on the unit.
CLEANING & MAINTENANCE
1.
2.
3.
4.
5.
6.
TPP630
TPP630
11
10
