Amulet High Definition Television Receiver User’s Guide
Copyright
2007 Entone, Inc. All rights reserved
.
12
CONNECTING THE TV USING COAXIAL CABLE
1.
Use the coaxial cable that comes packaged with Amulet to connect your TV’s antenna input to the
Amulet’s “RF TV”.
2.
Tune your TV to channel 10 to view the output.
NOTE
:
In the RF TV, it is factory set to use channel 10.
To set RF TV to another channel ID, please refer to section
Setting Channel ID.
Figure 4-1 Connecting TV using Coaxial Cable
SETTING UP TV TO USE CATV
In order for the Amulet to feed video signal to TV using RF TV, your TV must be configured to receive signal
from CATV rather than from the antenna.
Most TVs use either a physical switch located on the rear of the TV or with on-screen programming to
configure to use CATV. Consult your TV owner’s manual for instruction if required.
