© Enterpoint Ltd. – Polmaddie6 Manual – Issue 2.2 05/05/2017
6
Getting Started
Your Polmaddie6 will be supplied pre-programmed with a ‘traffic lights’ test design. The test
design will allow the user to determine that the LEDs and the push button switches of the
Polmaddie6 board are working. To use this test you should:
(1) Apply power to the Polmaddie6 board by plugging a cable into either of the USB sockets from a
USB power supply adapter or a PC Cable.
(2) The LEDs should light in a ‘traffic lights’ sequence. There is also Power indicator LED which
will light to show that power is present and the 3.3V regulator is working.
(3) Press SW2 (This is the left Push Button switch). The traffic lights sequence will be held in reset
until the switch is released.
(4) Press SW1 (This is the right Push Button switch). The traffic lights sequence will be held in
reset until the switch is released.
