KNOWN RESTRICTIONS AND LIMITATIONS
10/02/03 P/N: 9038090-53
Subject to Change Without Notice
Page: 25
of 31
F0615-J
Protocol Independent Multicast (PIM-SM)
I.D.
Using the
all
option of the
pim sparse set interface
configuration command fails to set the timer
options. Users must set these options individually, using each interface name and IP address.
F3251
Entering the
pim sparse set component mrt-spt-mult #
command from configuration mode places
the command in the router’s active configuration; however, the command
does not
appear in the
configuration for GateD and is therefore
not set
. To view the configuration for GateD, enter the
ip-router show configuration-file
command.
F3253
Quality of Service (QoS)
I.D.
The
qos set l2
command has no effect when the
low
,
medium
, or
high
priority parameters are
specified.
Example:
Entering the following command,
qos set l2 name HIGHP in-port-list et.7.2 dest-mac any priority high vlan 100
will not establish the priority of the L2 flow to
high
on vlan 100. Instead, the default priority of
low
will remain in effect for this flow.
NOTE:
The
control
priority parameter will function as expected.
F1950
Remote Monitor (RMON)
I.D.
RMON must be enabled in the CLI configuration before RMON MIBs may be accessed via SNMP.
F0832
Hot-swapping out a SERC line card and then hot-swapping the same card back in will cause RMON
to cease gathering statistics on that card.
F2227
Routing Information Protocol (RIP)
I.D.
RIPv2 will not export route tag information learned from other RIP routers.
F1681
Simple Network Management Protocol (SNMP)
I.D.
The
snmp show trap
command will not display any updated target information unless the
X-Pedition is rebooted.
F2068
Spanning Tree Protocol (STP)
I.D.
Traffic will not recover when Frame-Relay connections with a lower STP path cost are restored.
F2141
