Enterasys SecureStack C2, Configuration Manual, Page: 555 / 607

show multiauth
SecureStack C2 Configuration Guide 18-31
role. When a policy role is dynamically applied to a port as the result of a successfully
authenticated session, the “authenticated VLAN” is mapped to the policy role set in the Filter ‐ ID
returned from the RADIUS server. The “authenticated VLAN” may either be the PVID of the port,
if the PVID Override for the policy profile is disabled, or the VLAN specified in the PVID
Override if the PVID Override is enabled.
Commands
show multiauth
Use this command to display multiple authentication system configuration.
Syntax
show multiauth
Parameters
None.
Defaults
None.
Mode
Switch command, read ‐ only.
For information about... Refer to page...
show multiauth 18-31
set multiauth mode 18-32
clear multiauth mode 18-32
set multiauth precedence 18-33
clear multiauth precedence 18-34
show multiauth port 18-34
set multiauth port 18-35
clear multiauth port 18-35
show multiauth station 18-36
show multiauth session 18-36
show multiauth idle-timeout 18-37
set multiauth idle-timeout 18-38
clear multiauth idle-timeout 18-39
show multiauth session-timeout 18-39
set multiauth session-timeout 18-40
clear multiauth session-timeout 18-41