Installation
3-1
3
Installation
This chapter provides the instructions required to install the 2H252-25R. A Phillips screwdriver is
required to install options into the device or install the device into a rack. Follow the order of the
sections listed below to correctly install the device.
•
Unpacking the Device (
Section 3.1
)
•
Installing Options (
Section 3.2
)
•
Installing the Device (on a shelf or tabletop, or into a standard rack) (
Section 3.3
)
•
Connecting to the Network (
Section 3.4
)
•
Completing the Installation (
Section 3.5
)
3.1
UNPACKING THE DEVICE
Unpack the device as follows:
1.
Open the box and remove the packing material protecting the 2H252-25R.
2.
Verify the contents of the carton as listed in
Table 3-1
.
ELECTRICAL HAZARD:
Only qualified personnel should install the 2H252-25R.
NOTE:
Read the Release Notes shipped with the device to check for any exceptions to
the supported features and operation documented in this guide.
