Enterasys 08G20G2-08, Hardware Installation Manual

Page: 71 / 96

Enterasys 800-Series Hardware Installation Guide 3-1
3
Troubleshooting
This chapter contains instructions on troubleshooting the 800-Series as required. This can include:
Checking the LEDs
The following sections define the behavior of the LEDs on the 800-Series chassis models. The LEDs
on all chassis are located in the same location on the front panel.
Refer to Figure 3-1 for the location of the LEDs on the chassis.
Figure 3-1 Switch status LEDs (08G20G4-24 shown)
For information about... Refer to page...
Checking the LEDs 3-1
Troubleshooting Checklist 3-6
Removing the Switch from a Rack 3-7
Electrical Hazard:
Only qualified personnel should install or service this unit.
Riesgo Eléctrico:
Nada mas personal capacitado debe de instalar o darle servicio a esta unida.
Elektrischer Gefahrenhinweis:
Installationen oder Servicearbeiten sollten nur durch
ausgebildetes und qualifiziertes Personal vorgenommen werden.
1
Fan LED
4
Power (PWR) LED
2
Redundant Power Supply (PWR) LED
5
Copper 10/100/1000 Mbps port status LEDs
3
CPU LED
6
SFP 100/1000 Mbps port status LEDs