ENQUATICS AquaMaster Masters Decorative Series, Owner'S Manual

Page: 12 / 37

ELECTRICAL CONNECTION - UPGRADED PANEL
Upgraded Panel - reference page 32
Electrical Connection to be completed by licensed electrician in accordance with
the National Electric Code and local codes or ordinances.
WARNING: This unit is pre-wired and is provided with a GFCI for your safety
and the safety of your equipment in the event of an electrical short, ground
or equipment failure. DO NOT remove or modify the GFCI. Removal or
modifications could result in the danger of electrocution to any one, human or
animal, in contact with the water.

DO NOT bypass the supplied control panel. The control panel enclosure
is rain-resistant and includes a GFCI breaker and timer. Bypassing the
control panel could result in electrocution to anyone, human or animal, in
contact with the water.

Underwater splices are dangerous and will void the warranty. Electrical
cable(s) must extend completely onto shore to power source without
breaks or splices.

TURN OFF electrical power at fuse box or service panel before making
any electrical connections.

If supplied with a control panel, DO NOT bypass the control panel. The
control panel enclosure is rain-right and includes a GFCI breaker, timer,
contactor and overload assembly. Bypassing the control panel could
result in electrocution to anyone, human or animal, in contact with the
water.
ELECTRICAL CONNECTION TO CONTROL PANEL
TIMER PANEL ASSEMBLY
1. The unit comes with a timer panel that must be mounted vertically with the
cord holes downward to a solid structure. Correct mounting will prevent rain
entry into the timer panel.
2. Once the panel is securely mounted, open the front cover and plug the timer
panel into a 120V outlet using the power cord supplied.
3. Before installing the fountain into the pond, test run the fountain for 20
seconds by plugging it into the live outlet in the timer panel. The motor should
energize and run smoothly and quietly. Listen for any unusual noises. Do not
continue or install into the pond if the motor is noisy.
4. Install the fountain into the pond and refer to the anchoring instructions on the
following pages. Note: Improper installation can result in damaged property
and power cords.
5. Now the fountain is ready for final set up. Plug the fountain power cord into
the outlet labeled fountain. This will allow the timer in the panel to control
when the fountain is on and off.
6. Set the timer per the instructions found in the front cover.
ELECTRICAL CONNECTION TO CONTROL PANEL
WARNING: Make sure power is OFF !
1. Take the electrical cable from your unit and securely fasten it to the control
panel.
2. Connect black lead from cable to terminal marked 1T1 on terminal strip.
3. Connect white lead from cable to terminal marked 1T2 on terminal strip.
4. Connect green lead to grounding terminal.