Mount the Encharge Battery(ies) on the wall
*
WARNING
: Risk of injury. Take care when lifting.
Each Encharge battery base unit is heavy (44.2 kg/ 97 lbs) and
requires two persons to lift.
*
WARNING!
Risk of injury and equipment damage. Avoid
dropping the Encharge Battery(ies). Doing so may create a hazard,
cause serious injury, and/or damage the equipment.
*
WARNING!
Risk of injury and equipment damage. Protect the
Encharge Battery(ies) from impact damage and improper use.
A ) Two person together must lift a single Encharge battery base unit
from the packaging and place it right side up on a flat surface.
B ) Locate the Encharge lifting handles:
C ) If installing multiple battery units, plan to install the Encharge
battery unit located closest to the main supply.
D ) The first person lifting must slide the longer front handle under
the front edge of the Encharge battery, then tilt the handle up so
that handle tabs engage with the slots on the front side of the
battery.
E ) The second person lifting must slide the shorter side handle
under the left or right side (as needed) of the Encharge battery,
and support the upper back of the Encharge battery with their
free hand.
F ) Together, lift the Encharge battery and bring it to the already
mounted bracket.
G ) Hold the Encharge battery at an angle so the top of the unit sets
into the top of the wall-mount bracket.
*
WARNING!
Risk of injury and equipment damage. Do not
release the Encharge battery unit until you ensure that the
Encharge battery unit is fully seated in the wall-mount bracket
shelf.
H ) Once the top of the battery is engaged with the top tabs of the
wall-mount bracket, keep the battery vertical, make sure the
battery is flush against the bracket, and lower the battery down
until fully seated with the wall-mount bracket and set into the
bracket shelf.
I ) Remove the handles and reserve for the next Encharge battery
installation.
J ) Use a Phillips screw driver to loosen the screws securing the
field wiring compartment cover and remove the cover. Keep the
cover and screws handy as you will need them later.
K ) Attach the battery to the mounting bracket aligning the screw
hole at the top of the battery with the screw hole at the top of
the bracket.
L ) To record the installation of each Encharge battery base unit,
scan the serial number label using Enphase Installer Toolkit™
and your mobile device.
5
Top screw hole
DC Switch
Scannable serial
number label
Encharge side
handle in place
Encharge front
handle in place
Encharge front
handle
Encharge side
handle
P R
E L
I M
