Chapter 2 INSTALLATION
7.
Primary/Secondary IDE connectors (J4 & J5: Two 40-
pin
Blocks)
These connectors support the provided IDE hard disk ribbon
cable. After connecting the single end to the board, connect the
two plugs at the other end to your hard disk(s). If you install two
hard disks, you must configure the second drive to Slave mode by
setting its jumper accordingly. Please refer to the documentation
of your hard disk for the jumper settings. BIOS now supports
SCSI device or IDE CD-ROM boot-up (see “Boot Sequence” in
the BIOS Features Setup of the BIOS Software).
EP-PT22 User’s Manual
14
J5:
Secondary
HDD
J4:
Primary
HDD
