EMX-900
USER’S
MANUAL
72
EMX-900
USER’S
MANUAL
71
●
In case of no sound
Check if the volume is set to ‘0.’
Check if the connection of the earphone has failed.
●
Buttons don’t work
Check if the Hold switch is on.
●
“There is no file” message appears when pressing
Playback.
Choose the “Total” mode of [Playing Methods]
For more details, refer to the Playing Methods of this guide.
●
In case of no FM reception
For a fringe area where reception is poor, some radio signals
are hard to pick up.
Check if the connection of the earphone has failed. (The
earphone doubles as the antenna for the product.)
●
The system seems sluggish
Boot speed will a lot slower when there are too many files in
the unit.
Please refer to the page 26, Preparation.
Troubleshoot Checklist
FCC RF
INTERFERENCE STATEMENT
NOTE :
This equipment has been tested and found to comply with the limits for a
Class B digital device, pursuant to Part 15 of the FCC Rules. These limits
are designed to provide reasonable protection against harmful interference
in a residential installation.
This equipment generates, uses and can radiate radio frequency energy
and, if not installed and used in accordance with the instructions, may cause
harmful interference to radio communications. However, there is no
guarantee that interference will not occur in a particular installation.
If this equipment does cause harmful interference to radio or television
reception which can be determined by turning the equipment off and on, the
user is encouraged to try to correct the interference by one or more of the
following measures.
- Reorient or relocate the receiving antenna.
- Increase the separation between the equipment and receiver.
- Connect the equipment into an outlet on a circuit different from that to which the receiver is
connected.
- Consult the dealer or an experienced radio, TV technical for help.
- Only shielded interface cable should be used.
Summary of Contents for emx-900
Page 36: ......
