enorossi EASY RAKE 10, User And Maintenance Manual, Page: 8 / 74

User and maintenance manual
rev.0 – 02/12
SAFETY - 8
You must remember that the transportation configuration entails
closing the side arms and fitting the equipment with the following
safety devices:
-
Tie rods (1) to be fitted in position on the arms and frame, and
locked in place with their relative safety pins;
-
End stop device (2) to be inserted on the rod of the jack (to
prevent it from retracting) and blocked with its respective safety
pin;
-
Device (3) on the front wheels to limit their movement;
You must also comply with your national road regulations.
•
Installation: the device must only be installed on agricultural tractors
with universal three-point hitch system at the back and with hydraulic
lift.
IMPORTANT
The tractor must also, by law, be fitted with a protective roll-bar or
ROPS or FOPS cabin. It is strictly forbidden to install the rake
device on a tractor without the required protection.
Prior to installation, however, the Customer must check the tractor's
operating and maintenance manual to ensure the tractor is suited for
use and operation of the rake, and whether ballasts are needed to
prevent unbalancing that could cause it to tip over.
Instructions on installing the tiller and making the hydraulic
connections are given below.
2 m
1
3
2
6
1312
11
10
9
8
7
4