Enofrigo A1DOGEIBM10/W, Instruction Manual, Page: 29 / 103

The heating circuit cuts out Check the condition of the heaters and/or
thermal cut-out switches. If necessary, contact
the manufacturer or your local dealer and have
them replaced with identical products
There is too much water in the
tray Check the water level in the tray and bring it to
the level shown in chapter 13
The temperature of
the water is too warm The thermoregulator is not set to
the correct position Adjust the thermoregulator
Water constantly
present on bottom of
container The drain system is full Drain the water by pulling the plug located to
the left of the control panel (front view) or by
turning the drain tap
The water drain is blocked Check that there are no impurities in the
container drain hole
The lighting doesn’t
work The machine is not plugged into
the current socket Plug the machine in correctly
The power supply cable is
damaged or interrupted Check the condition of the cable. If necessary
contact a qualified technician to replace it with
another one of the same type
The main bipolar switch is off Turn the mains bipolar switch on.
The machine main switch is off Turn the machine main switch on.
There is a current interruption on
the control panel Check the condition of the control panel. If
necessary contact a qualified technician to
restore the current
The lighting switch is off Turn on the lighting switch
The lighting are broken or there’s
been a power failure Check the condition of the lighting. If
necessary, contact a qualified technician to
replace it with identical lighting
The hood is blocked
or difficult to move
(in models with
opening hood) The superstructure supporting
system is damaged Check the condition of the system. If necessary
contact the manufacturer or authorised dealer
for replacement
The steel cords supporting the
upper part are damaged Check the condition and smooth running of the
cords. If necessary, contact the manufacturer or
authorised dealer for replacement
The water loading
does not work Solenoid valve is broken or
missing water. Check the state of solenoid valve. Check water
pressure feed.
dA alarm displayed Missing water inside the tray Load water inside the tray.
EA alarm displayed Incorrect parameters Reset the thermoregulator.
Contact technical assistance.
ATTENTION:
In order to work the bathtub correcly it must be filled up of water until exceeding the level
sensor
CT68900002 Rev.0 09-13
29