Warning:
Changes or modifications made to this equipment not expressly approved by
EnOcean may void the FCC authorization to operate this equipment.
This equipment has been tested and found to comply with the limits for a Class B digital
device, pursuant to Part 15 of the FCC Rules. These limits are designed to provide reasonable
protection against harmful interference in a residential installation.
This equipment generates, uses and can radiate radio frequency energy and, if not installed
and used in accordance with the instructions, may cause harmful interference to radio
communications.
However, there is no guarantee that interference will not occur in a particular installation. If
this equipment does cause harmful interference to radio or television reception, which can be
determined by turning the equipment off and on, the user is encouraged to try to correct the
interference by one or more of the following measures:
•
Reorient or relocate the receiving antenna.
•
Increase the separation between the equipment and receiver.
•
Connect the equipment into an outlet on a circuit different from that to which the
receiver is connected.
•
Consult the dealer or an experienced radio/TV technician for help.
Due to FCC 15.231 operational and timing requirements the PTM 200 switch device must not
be operated more than 1088 times per hour
(pushed or released as one operation each):
•
Total duration of transmissions must not exceed more than two seconds per hour
•
STM250 packet length is 0.7 ms, max. 5 redundant packets, tolerance of 5% in packet
length, 50% on average packet Ton/Toff ratio
©EnOcean GmbH, A. Anders
Page 20 of 22
PTM 200 User Manual V1.1