QUICK START GUIDE
The Well Watch is nearly ready to go right out of the box. Follow the few steps below to
find the depth to water. If depth to the water is all you are interested in, then this is all
you need to read. To learn about the more advanced features continue reading the
operation section of this manual.
1.
Attach spout to well
. Insert the probe end into the vent hole on the well. If
the casing is open, it should be covered with anything solid such as rigid
plastic with a hole in it for the probe. The cover does not need to be air tight,
but the tighter it is, the stronger the signal will be.
2.
Turn meter on
. Apply power to turn the meter on. You should hear a
popping sound coming from the probe.
3.
Measure well
. Read the measured depth on the display. If the measured
distance is not as expected, then proceed to the next step to change the
initial settings.
4.
Change initial settings
. Press the SET button repeatedly to show the
various settings to be changed. Press the UP or DOWN button to change
setting. When set as desired, press SET again to change another setting or
press DISP to return to read the measured depth. For best depth results, the
range min
,
range max
, and the
well temperature
should all be set.
5.
Read other information
. While reading the depth display, press the UP or
DOWN buttons to read other information.
We encourage you to read the frequently asked questions section. They really are
frequently asked. Also, visit our website
www.enoscientific.com
for the latest manual
and installation tips.
Eno Scientific Well Watch 670
Page 6
