EN
28
3. Ensure that you have all the accessories
needed for assembly and operation.
Setting the operating position (Fig. B)
1. Push the operating handle (1) downwards
and pull the locking bolt (26) outwards
all the way to the stop and rotate 90º to
disengage it.
2. Lift the operating handle (1) to its full
height.
Mounting the extendable workpiece support
(Fig. C)
NOTE: Always use the extendable workpiece
support to ensure the stability of the
workpiece.
1. Slight loosen the extendable workpiece
support fixing nut (25) with the hex key. Do
not remove it from the base.
2. Insert the rod ends of the extendable
workpiece support (8) into mounting holes.
3. Slide the extendable workpiece support
inwards all the way to the top.
4. Tighten the fixing nut (25) to secure it
afterward.
5. Repeat the same steps for the other side of
extendable workpiece support.
Attaching the workpiece clamp
The workpiece clamp (15) is preassembled.
1. Loosen the workpiece clamp locking knob
(17), but do not remove it.
2. Insert the workpiece clamp (15) into the
workpiece clamp holder (16) on either side
of the base if necessary.
3. Fasten the workpiece clamp locking knob
(17) tightly.
NOTE: attach the workpiece clamp (15) on the
right side only if the bevel angle and the mitre
angle is adjusted so that the motor housing
does not interfere with the clamp.
Connecting the dust collection bag (Fig. D)
WARNING!
Always connect a dust extraction device when
using this product to keep the working area
clean.
Wear a dust mask when operating.
Dust can be harmful to health.
1. Attach the dust collection bag (21) onto
the dust extraction outlet (20). Ensure the
fastening clamp (21a) of the dust collection
bag sits properly around the dust extraction
outlet (20)
2. Open the zipper (21b) to empty the dust
collection bag if necessary.
Mounting on the bench
WARNING!
Make sure that the mounting surface is not
warped as an uneven surface can cause
binding and inaccurate sawing!
1. There are 4 mounting holes (9) on the base
to facilitate bench mounting.
2. Place the mitre saw on a level, horizontal
bench or work table and fix the saw on it
with the 4 mounting sets (not provided).
3. Carefully check the workbench or work
table after mounting to ensure that no
movement can occur during use. Secure
the workbench or work table to the floor
before operating in case of tipping, sliding
or other movement.
5. Operation
WARNING!
Make sure that the power supply voltage
matches the voltage rating indicated on the
appliance’s type plate.
Mitre angle adjustment (Fig. E)
1. Turn the turntable lock knob (24) anti-
clockwise to loosen it.
2. Rotate the turntable (12) until the mitre
angle pointer (10a) align with the required
angle on the mitre scale (10).
3. Tighten the turntable locking knob (24)
afterward.
