EN
27
●
Working position always sideway to the saw
blade.
●
Do not remove any cutting residues or other
parts of workpieces form the cutting zone
while the saw is running with unprotected
saw blade and the saw unit is not at rest.
●
Make sure that the saw is always secured
on a workbench or a stable table.
●
Support long workpieces to prevent them
sagging at the end of a cut.
●
Clean grease, oil and water off of the
clamping surfaces.
●
Do not use any loose reducing rings or
bushes for the reducing of holes on the saw
blades.
●
When transporting the saw, only use the
transport devices, never use the protective
devices for handling or transport.
●
Make sure the lower guard of the saw blade
is covered during transport.
●
Always use the clamp to fix the workpiece.
●
Ensure the mitre saw is always stable and
secure.
●
Always check the upper guard and lower
guard in position before use.
●
Always fix and use the extension supporter
during operation. And use additional
supports if needed to ensure the stability of
the workpiece.
●
Ensure that air vents are always
unobstructed and clear.
●
To let the saw blade cool down to avoid
overheating the saw blade tips when cutting
plastics, to avoid melting the plastics.
●
If the replacement of the supply cord
is necessary, this has to be done by the
manufacturer or his agent in order to avoid
a safety hazard.
●
Identify the correct saw blade to be used
for the material to be cut.
●
Use only a saw blade diameter in
accordance with the markings on the saw.
●
Warning! The maximum permissible mains
impedance Z
max
of the device is 0.449
Ω
. As
a user of this device, you must determine if
necessary in consultation with the energy
supply company that the device is only
connected to a supply whose impedance is
less than or equal to Z
max
!
Residual Risk
Even if properly operating and handling this
electric tool, some residual risks will remain.
Due to its construction and build, this electric
tool may present the following hazards,
a) Health hazard due to electrical power with
the use of improper electrical connection
cables;
b) Do not load the saw unnecessarily:
excessive pressure when sawing will quickly
damage the saw blade, which results in
reduced output of the machine in the
processing and in cut precision;
c) Cuts; hands may never enter the processing
zone when the machine is in operation;
d) Warning of electrical voltage. Electric shock
from insufficient insulation;
e) Ear damage if working without wearing ear
protection;
f) Hot surface. The insertion tool might still be
hot after the application. Do not touch it or
wear protective gloves;
g) Toxic Dust! Wear eye protection and a dust
mask.
4. Before use
WARNING!
Always disconnected with the plug from
the mains socket before working. Danger of
electric shock.
Unpacking
1. Unpack all parts and lay them on a flat
stable surface.
2. Make sure the delivery contents are
complete and free of damage. If you find
that parts are missing or show damage,
do not use the product but contact your
dealer or the service centre. Do not use the
product unless missing parts have been
delivered in addition or defective parts
have been replaced. Using an incomplete or
damaged product represents a hazard to
people and property.
