EN
37
counter- clockwise rotation (4).
1. Press the switch for clockwise / counter-
clockwise rotation (4) in all the way on that
side towards which the motor shall rotate.
(Fig.14)
- I : Screwing in
- II: unscrewing
2. Carry out a short test run to see whether the
rotational direction matches the intended
application. A wrong rotational direction
may damage the tool and / or workpiece.
3. If required, set the switch for clockwise /
counter-clockwise rotation (4) to centre
position (lock) to block the on/off switch (5).
Switching the device on and off (Fig.15)
The device has an infinitely variable speed
control. The more firmly you push the on/off
switch (5), the higher is the speed.
1. Check whether the tool clamped in and the
torque setting selected are suitable for the
intended application.
2. Check whether the workpiece is secured and
the worktop prepared correspondingly.
3. Press and hold the on/off switch (5) during
screwing or drilling.
- The device operates with the
previously selected settings.
- The LED work lamp (17) is illuminated.
4. Let go of the on/off switch (5) to stop the
device.
- The LED work lamp (17) turns off.
Info
The motor has an integrated brake that quickly
stops the motor once you let go of the on/off
switch (5).
Shutdown
1. Set the switch for clockwise / counter-
clockwise rotation (4) to centre position
(lock).
2. If required, allow the device to cool down.
3. Remove the battery from the device (see
Start-up
chapter).
4. Remove the tool from the device (see
Start-
up
chapter).
5. Clean the device according to the
Maintenance
chapter.
6. Store the device according to the
Storage
chapter.
7. Available accessories
Warning
Only use accessories and additional equipment
specified in the operating manual.
Using insertion tools or accessories other than
those specified in the operating manual may
cause a risk of injury.
Accessories
Spare battery
151218.01
Rock drill bit set,
15-piece
6.200.001.151
Screw bit set,
32-piece
6.200.001.001
Wood drill bit set,
15-piece
6.200.001.101
Metal drill bit set HSS,
15-piece
6.200.001.131
8. Errors and faults
The device has been checked for proper
functioning several times during production.
If malfunctions occur nonetheless, check the
device according to the following list.
Troubleshooting tasks which require the
housing to be opened must only be carried out
by an authorized specialist electrical company
or by EUROSPIN.
Slight smoke or odour are emitted during first
use:
• This is not a fault. These phenomena
disappear after a brief runtime.
The battery does not charge:
• Check whether the battery is correctly
connected to the quick charger.
Slide the battery into the quick charger in
a way that the battery terminals engage in
