6
•
Stand the iron on its heel and plug the power cord into wall socket.
•
Turn the iron temperature control knob until you get the desired fabric/temperature setting. We re-
commend using the above table as a guide.
•
The temperature pilot light is on, indicating that the soleplate is heating up.
•
When the pilot light is off, indicating the required temperature has been reached.
•
The temperature pilot light will go on from time to time during the ironing.
Dry ironing
•
For dry ironing, turn the steam control knob to “0”.This will cut off the steam flow if there is water is
in the water tank.
•
Turn the temperature control knob to select the desired fabric/temperature setting, the pilot light will
be on, put the iron on the smooth and stable place vertically.
•
After the indicating pilot light goes off, you can begin to iron.
SPRAYING
Ensure there is enough water in the water tank.
Press the spray button to produce a fine spray of water nozzle and continue ironing.
NB
. Do not spray silk.
STEAM-IRONING
•
As indicated on the temperature control knob on the iron, steam-ironing is only possible at higher
ironing temperatures (between “
•••
” e “MAX”).
•
Ensure that there is enough water in the water tank.
•
Stand the iron on its end; Insert the power plug into the wall socket.
•
Set the temperature control knob at the required position within the steam area.
•
After the indicator pilot light has gone off and come back on again, you may start ironing.
•
Turn the steam control knob to the required position. Adjust it to half steam or full steam
.
•
ATTENTION: Never direct the steam towards people. Burns or serious injury may occur.
STRONG STEAM
Ensure that there is enough water in the water tank.
When the temperature control knob is set to steam setting (between “
•••
” to “MAX”) strong steam can
be used.
Press the burst steam button, the soleplate will spray out strong steam.
NOTE
Fabric
Temperature control
NYLON/ACRYLIC/ACETATE
•
SILK/RAYON/POLYESTER
••
WOOL/COTTON
•••
LINEN
MAX
Setting the temperature
EN
