-4-
1199135-A02-B 07/09/2012
Centralise Door Assembly
between Wall Retainer and
Corner Post.
Position Return Panel between
Wall Retainer and Corner Post
so that the black lines at each corner
are not visible. DO NOT push the
PVC gasket into position at this
stage.
Mark corner of shower base
10mm in from front edges.
6
Fix both wall retainers in place us-
ing the 6 long screws. Make sure
the screws go into studs.
7
IMPORTANT
WHERE USED RAISED MODESTY LINE
PATTERN MUST FACE OUTSIDE OF
SHOWER
Fit 90
O
Corner Profile to Return
Panel Assembly and push into
position.
9
Move 90
O
Corner Post and
Return Panel Assembly out to
allow Door Assembly to be fitted.
10
Fit Door Assembly into Wall
Retainer Profile, then re-positon
Corner Profile and Return Panel to
Door Assembly.
11
Re-align 90
O
Profile to pre-
determined corner position.
12
13a
b
Note: If Screwing into backing
board only, use appropriate wall
anchors in the wall.
CAUTION: BEFORE DRILLING
HOLES, ENSURE THERE ARE NO
ELECTRICAL CABLES OR WATER
PIPES BEHIND WALLS
CAUTION: We recommend fixing the
wall retainers by screwing through
the backing board and into studs.
Other methods may cause warping
and might void warranty.
Insert return panel into wall
retainer so that the black mark
aligns with the edge of the wall
retainer. NB: The markings on the top
& bottom rails should be on the out-
side of the enclosure & the flexible
side of the PVC gasket on the inside.
8
DO NOT push the PVC gasket into
position at this stage.
