42 Serial FX Loop Send
43 Serial FX Loop Return
44 Poweramp Output, 4 Ohms Parallel
45 Poweramp Output, 8 Ohms Parallel
46 Poweramp Output, 16 Ohms
IMPORTANT NOTE, please read and heed:
Choose only one of the following speaker and cabinet options:
A) Speaker and cabinet options for the Raider Combo Amp - 1x12" model only:
Connect this output of the
to a signal processor's input/return jack using
the shortest possible shielded cord equipped with 6.3 mm (1/4") plugs. In the signal
path, the
is located post preamp, pre
, and pre power amp
and its two Master control knobs. The
is hardwired into the signal path.
If you wish to bypass a connected effect, you must do this on the outboard device by
switching it off or hitting its bypass button.
Connect this input of the
to a signal processor's output/send jack using
the shortest possible shielded cord equipped with 6.3 mm (1/4") plugs. In the signal
path, the
is located post preamp, pre
, and pre power amp
and its two Master control knobs. The
is hardwired into the signal path.
If you wish to bypass a connected effect, you must do this on the outboard device by
switching it off or hitting its bypass button.
4 ohms speaker output jacks, internal connected parallel. For diverse cabinet options
see
!
8 ohms speaker output jacks, internal connected parallel; the internal 8 ohms speaker
(1x12" combo: 1x 8 ohms) is connected to one of this two jacks. For diverse cabinet
options see the last chapter on this page! The impedance of an additional cabinet
should bear 8 ohms (for the Raider 112" Combo amp).
16 ohms speaker output jack; For diverse cabinet options see the last chapter on this
page!
Never operate the power amp without a
sufficient load, otherwise you may damage or destroy it! Always check the connected
cabinets' impedance to confirm it matches the amp's output impedance! For example,
if you are connecting a cabinet to one of the two 8-ohms output, make sure the
speaker system is indeed rated for 8 ohms. You'll find the various speaker and cabinet
options listed in the section below. I cannot stress enough the importance of proper
impedance matching when connecting one or more cabinets to your amp. Impedance
mismatching can damage the power amp!
1. Internal speaker (1x12", 8 ohms) only, connected to an 8-ohm jack
(without an external speaker cabinet!);
Summary: No external cab; internal 8 Z -> internal to 8-ohm output.
Serial FX Loop
Serial FX Loop
Main FX Loop
Serial FX Loop
Serial FX Loop
Serial FX Loop
Main FX Loop
Serial FX Loop
the last chapter on this page
17
