Stand By Switch
Power amp Stand By switch: Use this switch to protect the power tubes against wear (0 position) when
you take a longer break. The amp‘s tubes stay nice and toasty, and the amp is ready to roll immediately
when you ramp it back up to full power. Activates as soon as you set the Stand By switch to the 0 position.
Power Switch
Mains power on/off.
PLEASE NOTE:
ensure that the Stand By is set to Stand By (0 position) before you switch the amp on. Let the
tubes heat up for about 30 seconds before you activate the power amp. This procedure spares the tubes.
CAUTION:
After an extended period of operation and higher ambient temperatures the amps‘s chassis
can become very hot, therefore avoid touching the rear panel surface and the ventilation grille on the top!
