~43~
Re : “00” means all handsets
iv.
During phonebook transferring, LCD shows “Sending” and 2-digit
countdown on the LCD will indicate the remaining phonebook
numbers which are still pending to be sent.
c.
For the phone that is to receive the phonebook, press
2
to enter receiving
mode.
i.
When entering the receiving mode, the LCD will show “Ready”.
ii.
To start to receiving the phonebook, the LCD will show “Get
phonebook from Ext. # : xx” (the handset ID that will be doing the
sending).
iii.
A beep will be emitted when receiving each phonebook entry.
iv.
While receiving phone book entries, a 2-digit countdown on the LCD
will indicate the number of phonebook numbers remaining.
Re: Note: The phonebook transfer is via a wireless interface so there can be
times where some entries are not transferred due to interference. It
is recommended to have handsets in very close range during
transfers.
Call Barring
1. Block the users from dialing long distance or international calls. Call barring can
also be used to block incoming calls from an outside line or other registered
handset.
Note: Entering a password is required (default password is 0000).
2. Press
MENU
-4-3 to enter Call Barring. Enter the password
of the handset, followed by
OK
(Left) soft key
Block Outgoing Call
1.
Press
SELECT
left soft key to select “Outgoing” and confirm
your selection.
2. Use
or
scrolling key to switch between On and
Off of this setting. Press
SELECT
left soft key to confirm
your selection.
Re
：
：
：
：
The default setting of Call Barring is “Off”.
~44~
3. To enter a Call Barring code
a. Once the Call Barring feature is turned on,
you can key
in the “Call Barring” code.
Press
ADD
(Left) soft key then start entering the Call
Barring code after the number is entered, then press
the
SAVE
(Left) soft key to save.
(1) Up to 5 digits can be entered in as a Barring code. For
example, if you want to block all call dialing to
Manhanttan, NY area, you can enter 1212 as the Call
Barring code.
(2) If the base station is connected behind a PBX system, be
sure to include the outside dial tone digit as well
(example, 9 to dial out).
b. Press
OPTION
right soft key to delete or edit Call
Barring codes.
c. Up to 5 sets of Call Barring codes can be programmed.
d. If you want to block all outgoing calls, enter
＊＊＊＊
＊
keys followed by, press
SAVE
(Left) soft key to save.
Doing so will cause all outgoing calls to be restricted.
Block Incoming Calls and blocking intercom or broadcasts
from handsets.
1. Press
SELECT
left soft key to confirm your selection for
“Incoming”.
Use
or
scrolling key to select blocking item.
a. Press
SELECT
left soft key to confirm your selection to
block broadcasts.
Press
CHANGE
left soft key to switch between On and
Off of this setting.
Re: “On” means to be able to receive broadcast from
other hansets or base station. “Off” means to restrict
the broadcast from other handsets or base station. The
default setting is “On”.
