XF
Rev: 4, 2010-02-01
Page 19
Mount the drill template sticker and use and saw cutter or a file
to remove all needed area for installation. Pre-drill the four
fastening
holes with Ø2,4mm, (3/32”).
Remove the drill template and remove the red cover film from
the gasket.
Install the panel carefully and fix it in place with the four black
stainless screws.
6.3.
Connecting the joystick
Connect the wires to the panel as shown on the connection
diagram(s).
The wires are connected by pressing in the button placed under
the hole while the wire is being pushed into the hole. Release
the button when the wire is in place.
Check for good connection by pulling gently in the wires.
Correct connection is;
1. White (Direction 1)
2. Brown (Common)
3. Green (Direction 2)
4. Yellow (
+
supply from 1 A fuse connected after thruster
main switch or directly to MCU from MCU serial no.
200473 and later.)
6.4.
Connecting the control cable to the RCU
The wires are connected by pressing in the button placed over
the hole while the wire is being pushed into the hole.
Release the button when the wire is in place.
Check for good connection by pulling gently in the wires.
NB:
The wiring must be connected as follows:
Touch panel:
1. White
2. Brown
3. Green
Joystick :
1. White
2. Brown
3. Green
4. Yellow
For details, see the wiring diagram 6.12 and 6.13.
If more than one steering/control position in use, the wires must be
connected in parallel into 1, 2, 3 (and 4).