Eng3 4650-00, User Manual, Page: 23 / 44

eng
3
17
session mode. Enter the desired session time by pressing the plus and minus arrows of timer
mode. Select both the top and bottom buttons for this option.
Once you have selected one of the four operation modes listed above, press the page up arrow in the
lower right corner of the Owner Card administration screen. The device goes to the operating mode
that was selected and the owner card can be removed.
Selecting the page down arrow in the lower right of the Owner Card screen will take you to the screen
for programming User Cards, shown below.
3) Programming User Cards
The screen shown in Figure 8.4 indicates that you should insert a User Card to be loaded with
minutes. Remove the owner card and insert the first User Card to be loaded. To return to the Owner
Card screen press the page up arrow on the right.
Figure 8.4: Insert User Card for Loading
When the User Card is inserted, the screen shown in Figure 8.5 is displayed. The number of minutes
on the card can be seen at the top, above the SmartCard symbol. Selecting the + or
– before entering
the number of minutes through the touch screen, lets you add or subtract minutes on the card. Minutes
that were already on the card can be reduced or eliminated. Once the desired number of minutes
shows in the bottom display, press the load card button to load the User Card. Remove the User Card
and insert the next one, if you are loading multiple User Cards.
Figure 8.5: Loading User Card
Load card button