26
ENFORCER Access Control Keypad with Proximity Card Reader
SECO-LARM U.S.A., Inc.
Programming the Center LED Flashing during Standby Mode:
The keypad’s center green LED typically flashes while the keypad is in standby mode, but can be
programmed off if needed.
1.
Enable center green LED flashing during standby mode (default):
73 1 #
2.
Disable center green LED flashing during standby mode:
73 0 #
Programming the Door-Forced-Open Warning and Timing:
If the keypad is connected to an optional magnetic contact or other door protection switch or
device, the keypad can be programmed to beep when a door has been forced open. The keypad
beep can be set to activate for 1 to 999 seconds.
1.
Door-forced-open warning OFF (default):
80 0 #
2.
Door-forced-open warning ON:
80 ttt #
NOTE
:
•
TTT
represents the beep and alarm output active time, which can be set from 1 to 999
seconds.
•
If programmed for door-forced-open warning, the keypad will beep if the door is forced open
without using a user code and/or card or the egress button. The keypad will not beep if the door
is opened with a user code and/or card or the egress button.
•
The door-forced-open warning and the door open alarm should not both be enabled, as the
overlap in timing could result in incorrect alarm outputs (see “Programming the Door Open Alarm
and Timing” on page 27).
