ENFORCER 50ft Large Reflective Beam Sensor
6
SECO-LARM U.S.A., Inc.
L-Shaped Mounting Bracket (Reflector):
1.
Loosen the captive screw at the bottom of the reflector. Slide the mounting plate downwards
and remove it from the unit.
2.
Using the included short screws, attach the L-shaped mounting bracket to the mounting plate
(
fig. 5
). Secure the bracket to the wall or surface using the included mounting screws. Use
optional anchors for brick or drywall (not included).
3.
Slide the reflector into position on the mounting plate and secure them in place by tightening
the captive screw.
Installation
(continued)
Sample Installations:
Configuration 1
Configuration 2
Configuration 3
1.
Configuration 1: Sensor and reflector are mounted facing each other.
2.
Configuration 2: Sensor and reflector are mounted on perpendicular surfaces.
3.
Configuration 3: Sensor and reflector are mounted on parallel surfaces, but the units are
mounted perpendicular. The reflector is mounted with the L-shaped bracket.
Top View
Side View
Top View
Side View
Top View
Side View
Fig. 5
ENFORCER 50ft Large Reflective Beam Sensor
SECO-LARM U.S.A., Inc.
3
Overview:
Sensor
Reflector
Cover
Signal LED
Response time
adjustment
knob
Horizontal
adjustment
bracket
Lens
Terminals
Alarm LED
Voltage output
probes
Vertical
adjustment
screw
Alignment
viewfinder
Captive
screw
Cover screw
Power LED
Parts List:
1x Sensor
1x Reflector
2x Hoods
2x Mounting plates
2x Mounting brackets
2x Pole mounting brackets
1x L-Shaped mounting bracket
4x Mounting screws
4x Long screws
6x Short screws
1x Rubber gasket
Dimensions:
Sensor with hood
Reflector with hood
3
3
/
16
” (81mm)
3
9
/
16
” (91mm)
7
3
/
16
”(
18
2m
m
)
3
3
/
16
” (81mm)
3
9
/
16
” (91mm)
