1150-HB-KNXnetIP-Interface-en-1.odt, 2018-08-06
Seite 6 von 6
tunnel [1..5]
Show tunnel addresses and connection status (without option), or show detailled information
for a specific tunnel (option 1..5)
CCID: connection id of the tunnel connection
KNX address: tunnel address
HPAI control: control-end-point of the receiver
HPAI data: data-end-point of the receiver
Connect. Type: tunnel connection or management connection
TX tun req: number of telegrams sent to this tunnel
TX tun re-req: number of telegrams that had to be repeated for this tunnel connection
RX tun req: number of telegrams received from this tunnel
RX tun re-req: number of telegrams that have been received twice for this tunnel connection
RX tun req (wrong seq.): number of telegrams with wrong sequence number that have been
received for this tunnel
version
Show firmware version
Reset to factory defaults
To reset the device to factory defaults, press and hold the programming mode button for three
seconds. When the red LED starts blinking release the button. The device shuts down and will
reboot with factory settings automatically.
ETS database
You can download the latest version of the product's ETS database from our homepage:
http://www.enertex.de/e-downloads01.php
Technical data
Stromversorgung
16-24 V AC or 20-30 V DC; IEEE 802.3af („Power over Ethernet“)
Power consumption
Max. 1 W
KNX Funktionen
KNXnet/IP tunneling
KNXnet/IP Tunnelling
Up to 35 telegrams per second, up to five tunnel connections
Enertex
®
Bayern GmbH – Ebermannstädter Straße 8 - 91301 Forchheim - Deutschland - [email protected]
