Enertech Bentone BFG1, Installation And Maintenance Instruction

Page: 22 / 48

22 Bentone BFG1
!
Warning
!
When servicing/replacing components which affect the combustion, gas side leakage analysis and check
should be performed on the system.
4. Burner Service
4.1 Service
Service should be performed after approx. 3000 working hours, but no less
than once a year.
Only authorized personnel should perform the service.
Before any kind of service is performed, switch off the current with the line
breaker and turn off the gas supply.
Be careful: certain parts exposed after the separation of the burner can be
warmer than 60°C.
Be careful not to pinch or damage any electric cables or gas pipes during
installation or service.
4.1.1 Combustion device service
1. Switch off the main current, disconnect the 7-pole Euro plug from the
burner and turn off the gas.
2. Remove the gas pipe after ensuring that the gas is turned off.
3. Remove the burner from the burner flange. Pull out the burner.
Disconnect the blast tube and remove it.
4. If necessary, clean the brake plate and nozzle.
5. Check the ignition electrode and ionisation electrode. Replace if
necessary. (Refer to Technical data for setting of electrodes)
6. Install on the blast tube and fasten the burner on the burner flange.
7. Install the gas pipe.
8. Check the gas pipe for leakage.
9. Install the 7-pole Euro plug, switch on the main current and open
the gas flow.
10. Start the burner and check the combustion.