10
C048-693-30 R02, Rev. B (04/2020)
4.7
4.7 Rear Safety Cover Installation
Rear Safety Cover Installation
WARNING! ELECTRICAL HAZARD
FAILURE TO INSTALL THE PLASTIC SAFETY SHIELDS
PROPERLY MAY CREATE AN ELECTRICAL HAZARD�THE
PANEL MAY BE ENERGIZED WHEN INSTALLING THE
REAR PLASTIC SAFETY COVERS�
The HDX product includes a rear safety cover which is to be
installed around the rear eletrical terminations� The cable
knockout points in the plastic will need to be trimmed to match
your input/output cable configuration. Once this has been
completed, proceed to the following steps:
Step 1.
Install the included #8-32 panhead screws into the
threaded holes on the sides of the panel�
Step 2.
Slide the cover onto the screws installed, then tighten
down the screws to secure the cover�
4.8
4.8 Installing Breakers
Installing Breakers
Refer to Table 11 on Page 13 for a list of supported breakers�
Step 1.
Ensure breaker to be used is in the OFF position�
Step 2.
Ensure that connected loads are in the OFF position�
Step 3.
Insert a breaker of sufficient ampacity into the position to
be fed�
Step 4.
Ensure that the breaker is fully seated�
Step 5.
Turn on the connected load�
Step 6.
Inventory the breakers (See Section 5�2 "Breaker
Inventory For HDX ABC 10" and Section 5�3 "Breaker
Inventory For All Other Models" on Page 11)�
