4
NAME OF PARTS
1
Output cable: Please check “Cables & Connectors”
section.
2
13.5cm fan
# 1
3
Honeycomb air vent
# 1
4
PowerGuard LED
5
CordGuard
#3
6
AC Inlet
# 2
7
ON/OFF switch (I=ON, O=OFF)
# 2
#1 To ensure best system cooling, do not block PSU fan’s air in-take and air vent area.
This PSU offers a special HeatGuard function. When the system is turned off, or goes into ACPI
S3/S4 sleep mode, the PSU fan will keep dissipating the remaining heat for 30 ~ 60 seconds and
prolonging system lifetime.
#2 When assembling or maintaining the system, please remove AC cord from AC inlet, or turn
ON/OFF switch into “OFF” position, and wait PowerGuard LED light off. Then you can safely
service the system.
#3 AC cord can get loose in many ways. The ENERMAX CordGuard lock can fix your AC cord
tightly to the PSU, so that it will not be easily detached and avoid shut-downs of your PC. The
following is CordGuard installation:
①
Set your PSU into the chassis, and please
make sure the I/O switch is on “O”
position.
②
Press two sides of the CordGuard lock
together, and set it into CordGuard holder
near the AC inlet.
③
Plug the AC cord into your PSU.
④
Lock CordGuard to latch onto AC cord.
1. CordGuard is for AC cords supplied with ENERMAX CordGuard-compatible PSUs. Other AC
cords may be incompatible.
2. When assembling or maintaining the system, please remove AC cord from AC inlet, or turn I/O
switch into “O” position.
CABLES & CONNECTORS
All connectors are designed to prevent insertion in wrong orientation. If you cannot easily insert a
connector, please check if you are inserting the connector in the right orientation. Do not try by force
to insert it nor modify the connectors. This might damage power supply and system components, and
warranty shall be void.
ENGLISH
