background image

www.hi-velocity.com

•  Inoperative parts must be returned to Energy Saving Products Ltd. with an ESP RMA Form that 

includes model, serial number, and a detailed description of the entire problem. Inoperative 

parts must be returned in testable condition.

•  The warranty does not cover shipping costs to and from the factory, labour costs or any other 

cost associated with the installation of the replacement part.

•  Energy Saving Products Ltd. is not liable for any other damages, personal injury, or any other 

losses of any nature.

•  The liability of Energy Saving Products Ltd. is limited to and shall not exceed the cost of pre-

approved replacement parts.

Energy Saving Products Ltd. reserves the right to make changes to, improve upon, or discontinue its 

products at any time without public notice or obligation.  The descriptions and specifications contained in 

this document were in effect at printing.  Some illustrations may not be applicable to your unit. 

WARRANTY

three year limited warranty

 is extended on Electric Strip Heaters.

five year limited warranty

 is extended on all components in products manufactured exclusively by Energy 

Saving Products. These components include Motors, WEG Controller, Circuit Boards, Dampers, Zoning 

Controls, Blowers, Motor & Blower Assemblies, Heating Coils, Chilled Water Coils, and Air Conditioning 

Coils. 

Energy Saving Products Ltd. is proud to offer a limited warranty. This warranty applies strictly to the first 

purchaser at wholesale level and only to the fan coil unit and module. It does not include connections, 

attachments and other products or materials furnished by the installer.

Terms and Conditions

•  Any repair performed under warranty must be approved by Energy Saving Products Ltd. for this 

warranty to be valid.

•  This warranty replaces all other warranties expressed or implied. www.hi-velocity.com
•  Should there be multiple consecutive failures of a single part, warranty will not be considered 

until a contractor has contacted Energy Saving Products Ltd. Technical Department for assistance.  

Follow these steps for Service or Repair:

1. 

Contact the installer of the product or a licensed service company                                                                   

2. 

Contact the distributor      

 

 

 

 

 

                                        

3. 

Contact Energy Saving Products Ltd.  Mon-Fri  8 am – 4:30 pm MT  1-888-652-2219

This warranty excludes any damages caused by changes, relocation to, or installation in a new site. This 

warranty does not cover any defects caused by failure to follow the installation and operating instructions 

furnished with the fan coil. This warranty does not cover defects caused by failing to adhere to local 

building codes and following good industry standards. Failure to correctly install the fan coil, or material 

related to the unit, may result in improper system performance and/or damages and will void this warranty. 

This warranty does not cover products subjected to abnormal use, misuse, improper maintenance, or 

alteration of the product. Using the fan coil and/or module as a source of temporary heating/cooling 

during construction will void this warranty. 

Products sold by Energy Saving Products but manufactured by others, will carry the original manufacturer’s 

warranty. 

Summary of Contents for Hi-Velocity RCM-I Series









Reviews: