4
This fixture is warranted to perform free from defects for five years. If it fails to do so, you may
return it with proof of purchase to 13445 12th St., Chino, CA 91710 for replacement.
Clean with a mild, non-abrasive glass cleaner and soft cloth. Do NOT use solvents or clean-
ers containing abrasive agents. When cleaning the fixture, make sure the power is turned
off, and any liquid spray should be applied to the cleaning cloth and not sprayed directly onto
the fixture itself.
www.energeticlighting.com
INSTALLATION INSTRUCTIONS
INSTALLATION INSTRUCTIONS
CARE AND MAINTENANCE
TROUBLESHOOTING
WARRANTY
Problem
Possible Solution
Corrective Action
Fixture does not light.
Circuit breaker trips
when light is turned on.
1. Power is off.
2. Incorrect wire connection.
3. Defective wall switch.
Crossed wires or power
wire is grounded out.
Verify wires are correctly
connected.
1. Check circuit breaker
or wall switch.
2. Check wire splices.
3. Replace switch.
2. Prior to mounting the back plate to the mounting
surface, apply silicon sealant (not provided) around
the perimeter of the junction box to seal out water
from entering the wiring compartment. Align the back
plate (B) with the junction box so that the back plate is
flush against the mounting surface and the tabs are
located in the upward direction. Route the supply
wires from the junction box through the center
opening of the back plate (B).
Fig. 2
4. Tuck the wires and wire nuts into the junction box and
align the back plate (B) tabs with the support notches
on the mating face of the fixture body (A). Angle the
fixture body so that the top edge of the tabs enter the
notches first and once fully seated rotate the body
down until it sits flush against the back plate and
mounting surface. Ensure that the fixture is fully
supported by the back plate before releasing the
fixture from your hands.
Fig. 4
AA
3. Apply more silicon sealant around the mating edges
of the body to the mounting surface and back plate to
seal out the elements from the wiring campartment.
Hold the fixture up to the mounted back plate (B) and
connect the supply wires to the fixture wires -- black
to black, white to white, and green to copper/bare.
WARNING:
If there is no ground supply wire, stop
installation and consult a qualified electrician.
Once wire connections are made, secure each with a
wire nut (AA).
Fig. 3
5
Printed in China
www.energeticlighting.com
5. Reinstall the retaining screw (C) back into the bottom
of the fixture body (A) and check to ensure that the
fixture body is locked in place before completing the
installation.
Fig. 5
Seal with
silicone
sealant
Seal with
silicone
sealant
A
C
B
B
BB
Back Plate Tabs up
A
