1400W MITRE SAW ENB475MSW
Four holes are provided in the base of the saw to
enable it to be fixed to a bench, or other supporting
surface.
To mount the saw, proceed as follows:
1) Locate and mark where the saw is to be mounted.
2) Drill 4 holes through the surface.
3) Place the mitre saw on the surface aligning holes
in base with holes drilled in the surface. Install bolts,
washers and hex nuts.
4. Workpiece clamp
(Fig.6)
When cutting workpiece, the boards should always
be clamped with a hold-down clamp (provided) as
shown in Fig.6.
1. RELEASING THE SAW HEAD (Fig.7, 8)
When boxed or during storage, transportation, the
saw head is locked in the down position. To release
the head ready for operation, apply downward
pressure and pull out the lock pin (b). The head will
be raised gently to upper position.
2. TO MAKE A CUT (Fig. 9)
1) Connect the machine to power outlet, ensure that
the mains cable is clear of the blade and the base
plate.
2) Position the material to be cut on the rotary table,
ensure it is firmly held so that it will not move during
cutting.
Ensure that the rotary table locking screws(17) and
the bevel lock (19) are tightened before cutting.
3) Press the switch trigger (16) and allow the saw
blade to run up the speed.
4) Still holding in the trigger, press the safety
release latch (3) towards the handle. It will then be
possible to push the saw head down by the handle.
5) Continue to move the saw head down smoothly
and make the cut exerting only gentle pressure on
the downward stroke, letting the saw do the work.
Fig.7
Fig.8
Fig.9
OPERATION
b
3
16
Fig.6
