710W PLANER ENB466PLN
Operating instructions
1. Adjusting the depth of cut
The cutting depth can be adjusted from 0-2mm.
To set the cutting depth, rotate the depth adjustment knob to
the required setting indicated by the cutting depth
scale.(Fig.1)
The scale is calibrated in 0.25mm per step/total 8 steps.
Note
If it is necessary to accurately determine the depth of cut,
plane a scrap piece of wood, measure the difference in
thickness and adjust the setting if necessary.
For optimal quality of cutting, please start with a small
cutting depth and increase in increments until you reach the
desired depth.
.
2 Adjusting the with of cut
The cutting width can be adjusted from 0-82mm.
To set the cutting width, Install the guide to the machine
(Fig.2).
rotate the knob on the guide to the required width and then
lock the guide.(Fig.3)
3. On/Off switch
Use the On/Off switch and lock off switch to start the
machine and keep holding it for continuous operation.
The machine can only be started by depressing the lock off
switch first, preventing any unintentional operation.
To switch the machine off, release the On/Off switch.
CAUTION!
Always hold the machine by both hands.
Never start the planer with the blade in contact with the
workpiece. Start cutting only after the motor reached its full
speed.
Always carry out a test run before starting work and after
every tool change! Always ensure that the tools are in good
condition, correctly mounted and able to turn freely. The trial
run should be at last 30 sec.
Fig.1
Fig.4
Fig.2
Lock-off button
On/off switch
Depth scale
Width adjustment
knob
Fig.3
