810W 115mm ANGLE GRINDER ENB461GRD
4.
ON/OFF SWITCH
Use the On/Off switch and switch lock to start the
machine and keep holding it for continuous operation.
The machine can only be started by depressed the
switch lock first to preventing any unintentional
operation.(Fig.4)
To switch the machine off, release the On/Off switch.
VIBRATING DISCS MUST BE REPLACED
IMMEDIATELY.
Please always keep other persons and combustible
material from work area.
Please always make sure work with guard and disc in
position before start the machine.
5. MOUNTING DISC (Fig.5)
Depending on the working condition, always select a
suitable type and thickness of the disc.
The mounting hole of disc must fit with the mounting
flange. Do not use reducers or adapters.
CAUTION!
Never use discs whose diameter is larger than that
indicated.
The maximum rotation speed of disc must be greater
than the rated speed of the machine.
WARNING
: Only use discs with a diameter of 115mm,
bore size 22.5mm and with a max speed of 12000min
-1
To assemble the disc, press the spindle-lock button in
deep and hold it in this position continuously. If
necessary, turn the spindle slightly with the free hand
until it locks into position.
The inner flange is located over the spindle and on the
two spindle flats. Locate the disc onto the inner flange
and then the outer flange is screwed on to the spindle.
Check the disc rotates freely and is securely clamped.
CAUTION!
Always carry out a test run before starting work and
after every tool change! Always ensure that the tools
are in good condition, correctly mounted and able to
turn freely. The trial run should be at last 30 sec.
Fig.4
Fig.5
