Energate Z100 P2, Operating And Installation Manual

Page: 14 / 64

Temporary Hold
A Temporary Hold allows you to temporarily make the temperature warmer or cooler without
affecting the pre-set programming. The thermostat will remain at the Temporary Hold temperature
until the next scheduled SETPOINT.
From the Home screen, press either of the SCROLL buttons to
adjust either the HEAT (if the current operating mode is HEAT) or the
COOL (if the current operating mode is COOL) of the active target
SETPOINT, shown below the room temperature, with two arrows
beside it.
To accept the adjusted SETPOINT press the
LEFT TAB .To cancel,
press the RIGHT TAB . Note that even if you don’t press the ACCEPT
tab, the Temporary Hold will take effect when the screen goes on
idle (i.e. the screen backlight diminishes to low).
When the thermostat mode setting is AUTO, pressing the MENU /
SELECT button will switch between the HEAT and COOL
SETPOINTS (i.e. the screen will show “ADJUST HEAT” or “ADJUST
COOL” respectively). The
LEFT TAB accepts the Temporary Hold
settings and the RIGHT TAB cancels them.
Page 14