14
©2010 Enerdrive Pty Ltd
4. Operation
The AGS Remote Control is equipped with a wide range of easy-to-use switches and
displays, allowing you to quickly setup your inverter/charger as well as determine
its operational status. The “AGS” soft key controls the operation of the networked
AGS Controller (refer to figures on page 11).
Rotary SELECT Knob
Similar to a dash radio knob, use the SELECT knob to move between menus and
select program options. Turn the knob clockwise to increase value or counter-
clockwise to the decrease value. Press the knob to “save” the selection.
AGS Soft Key
Press the AGS soft key to access AGS menu and then turn the rotary “SELECT”
knob to view the following menu items (refer to table 2 on page 14).
AutoGenSt Cntrl -
Used to turns the AGS (Auto Gen Start) ON and OFF or to enable “Quiet Time.”
AutoGenSt OFF -
Disables the Auto Gen Start function.
AutoGenSt Enabl -
Enables the AGS system to automatically start the generator based on the coach’s
interior temperature or low battery voltage conditions. Temperature and voltage
settings are selected using the AGS Controller (page 11).
AutoGenSt Test -
Starts and runs the generator for 30 seconds, fully testing the AGS system.
AGS w/Quiet Time -
Identical to the ENABLE setting above but sets QUIET TIME. When this selection
is made, the Set Current Time (clock) menu appears, prompting you to set the
current time. Set the required “QUIET TIME” hours using the AGS Controller (see
pages 10 - 11).
NOTE: If the generator is running when START QUIET TIME is reached, it will
automatically stop and will not start again until END QUIET TIME is reached.
Set Current Time -
When you access the Set Current Time menu, press the Select knob. This displays
the “Set Hour” menu. Turn the SELECT knob clockwise to increase the hour or
counter-clockwise to decrease the hour. Press the knob to save the setting and
advance to the “Set Minutes” menu. Repeat the steps and advance to the “Set
AM/PM.” Press the knob to save your selection.
NOTE: If the current time is correct, you can press any of the soft keys
to escape without affecting the settings or the press the SELECT knob to
advance through the various fields.
