3
1. Safety Instructions
• Read these safety instructions and the operation manual first before you install and
commission the camera.
• Keep the manual in a safe place for later reference.
• Protect your camera from contamination with water and humidity to prevent it from
permanent damage. Never switch the camera on when it gets wet. Have it checked at an
authorized service center in this case.
• Never operate the camera outside of the specifications as this may prevent the camera
functioning.
• Do not operate the cameras beyond their specified temperature, humidity or power ratings.
Operate the camera only at a temperature range of -0°C to +50°C and at a humidity of
max. 90%.
• To disconnect the power cord of the unit, pull it out by the plug. Never pull the cord itself.
• Pay attention when laying the connection cable and observe that the cable is not subject to
heavy loads, kinks, or damage and no moisture can get in.
• The warranty becomes void if repairs are undertaken by unauthorized persons.
Do not open the camera housing.
• Never point the camera towards the sun with the aperture open. This can destroy the sensor.
• Installation, maintenance and repair have to be carried out only by authorized service centers.
Before opening the cover disconnect the unit from mains input.
• The fitter is responsible for the system of protection being followed in accordance with the
technical data, e.g. by sealing of the cable outlet with silicone.
• Contact your local dealer in case of malfunction.
• Only use original parts and original accessories from Videor E. Hartig GmbH.
• Do not use strong or abrasive detergents when cleaning the dome. Use a dry cloth to clean
the dome surface. In case the dirt is hard to remove, use a mild detergent and wipe gently.
• It is unavoidable that, during manufacturing and also during subsequent use, the moisture
contained in ambient air is, to some extent, present in the housing. With strong temperature
variations, the moisture may develop condensation within the housing.
In order to avoid this in the tightly locked housing, the manufacturer has inserted silica gel
bags inside the camera.
It is a physical fact that these silica gel bags do reach saturation after a while.
They must therefore be replaced with new silica gel bags.
• During assembly, care must be taken to ensure that existing seals are correctly
inserted and are not displaced as a result of assembly.
You must not continue to use damaged seals.
