Eneo INB Series, User Manual

Page: 40 / 74

User Manual
39
8.7.1.2
、
PD&VD
It help to identify the person or vehicle shapes in the detection areas, and generate an alarm and
record the corresponding snapshot according to setting parameters.
Enable
：
Enable/Disable PD&VD function
Sensitivity: Set its sensitivity parameters, its range is 0~100. The higher the detection sensitivity, the
better it can detect the target of people or vehicles, but the higher the false alarm will be Enable/Disable
Dynamic Marking option
Snap Mode: set the capture mode. The program supports three capture modes.
You can view the capturing effect in the Preview interface or in NVR port when push receiving is
on .
Default
：
Pushes a picture of a person or car when the target disappears
Real-time Mode
：
When a camera detects one target, it immediately pushes a picture, and then
pushes another picture with the best effect when the target disappears.
Interval Mode
：
Set the number of shots and the interval between shots and push pictures as
needed. Snap number can be set to 1, 2, 3 and unlimited. Snap frequency: the time range is 1-255
seconds. If it is set to 5 seconds, a push will be generated respectively at 5, 10 and 15s when the target is
detected.
Min Pixel: allow you set < Min Pixel > value
Its defaulted resolution: 64*64
The setting range: 32~1080 pixels
Max Pixel: allow you set < Max Pixel > value
Its defaulted resolution: 640*640
The setting range: 320~1080 pixels
Detection Type
：
Allow you select Pedestrian, Motor Vehicle and Non-motorized Vehicle
Set Detection Mode, there are two mode to select
：
Static Mode
：
Detect all people or vehicles in the picture
Motion Mode
：
Detect some moving people and vehicles in the images
Set Detection Range, there are two modes to select:
Full Screen
：
Detect all the areas that can be monitored by the camera
Customize
：
Only detect the area selected by quadrilateral frame.
Rule line Setting Area: When select the <Customize> option, you can set the quadrilateral frame at