Endura PanoLock Instructions Download Page 2

Page: 2 / 4

PanoLock

™

- Lock Assembly & Handing

Secure lock with installation screws.

STEP 5

Two #8 x 3" Screws: Place through open holes

just above the latch, and just below the spring

adjuster screw.

Four #8 x 1-5/8" Screws: Place through

remaining open holes.

Lock Handing - The angled surface of the latch faces

the strike plate.

STEP 6

To rehand the lock, loosen the latch screw with a

9/64" allen wrench.

STEP 7

#8 x 1-5/8"

Screw

#8 x 1-5/8"

Screw

#8 x 3"

Screw

#8 x 3"

Screw

#8 x 1-5/8"

Screw

#8 x 1-5/8"

Screw

Summary of Contents for PanoLock

Page 2: ... latch and just below the spring adjuster screw Four 8 x 1 5 8 Screws Place through remaining open holes LockHanding Theangledsurfaceofthelatchfaces the strike plate STEP 6 To rehand the lock loosen the latch screw with a 9 64 allen wrench STEP 7 8 x 1 5 8 Screw 8 x 1 5 8 Screw 8 x 3 Screw 8 x 3 Screw 8 x 1 5 8 Screw 8 x 1 5 8 Screw ...

Page 3: ...Lift latch away from lock rotate 180 degrees place back into lock STEP 8 Slots on back of latch must align with ribs at bottom of latch hole Note placement of roller sleeve latch and screw Tighten screw to secure latch in place STEP 9 ...

Page 4: ...ktothestarting position to disengage the upper lower and center latches Use the screwdriver to push the pin to the right The latch should fully retract Push down on either of the multipoint latches The latch should remain extended Pushdownonthecenterlatch Thelatch should remain extended Check lock function ...