WARNING: Make sure your Sonoma can lock to GPS with the
antenna in this window before proceeding. Once installed, tape
(shown in Figure 1) may be destroyed if bracket is removed from
window. Spare tape is provided in case you need to relocate. Do
not use more than 1” of tape as shown.
Form 5050-0023-000
November 2017
GPS Antenna Window-Mounting Guidelines
��������
��������������������
����������
�����������������
��������
��������������������
������������������
�������������
Santa Rosa, CA, USA
1-877-749-3878 or 707-573-8633
www.endruntechnologies.com
Santa Rosa, CA
[email protected]
www.endruntechnologies.com
"Smarter Timing Solutions"
Step 1
Separate antenna into two sections by loosening the four screws.
The lower section will not be used.
Step 2
Slide top half of antenna into mounting bracket as shown in Figure
2. Use two screws supplied in kit to secure into bracket.
Step 3
Insert cable tie through the two holes at the bottom of the bracket
as shown in Figure 2.
Step 4
Clean dust from window in mounting location. Remove backing
from tape and position bracket in window mounting location.
Firmly press bracket, seating exposed tape against window surface.
Step 5
Re-connect cable to antenna. Route cable to prevent kinking,
avoiding sharp bends and providing adequate strain relief. Figure 3
illustrates best installation method using supplied materials.
REMOVAL: Hold the bottom part of the bracket and slowly pull
away from window.
��������
�������������������
�������������
���������������������
�������������������������
���������������
���������������������
