M e r i d i a n I I U s e r M a n u a l
132
C H A P T E R E L E V E N
133
M e r i d i a n I I U s e r M a n u a l
R E A L - T I M E I O N O S P H E R I C C O R R E C T I O N S ( R T I C )
RTIC Configuration
and Status
If the RTIC Option is installed in your unit, then you can configure (turn on or off) and get status in-
formation via the front-panel keypad/display or the command line interface. To confirm whether this
option is installed from the command line issue the following command:
Command:
installed_sw_opts
Meridian II reply:
The Real-Time Iono Corrections Option is Installed.
(If the option is installed.)
If you need information on how to install the RTIC option, refer to
Appendix I - Software Options
.
RTIC Configuration and Status Using the Keypad/Display
If your unit has the optional RTIC capability then there will be an item in the list of Receiver selec-
tions called: “RTIC”. Press the RIGHT/LEFT arrow key until this is highlighted and press ENTER
to select it. Then press the RIGHT/LEFT arrow keys to highlight “Status” or “Setup” and press
ENTER.
The “Status” selection will let you see the current status of the RTIC.
The “Setup” selection lets you turn RTIC on or off.
Summary of Contents for Meridian II
