F D C 3 3 0 0 U s e r M a n u a l
22
A P P E N D I X C
23
F D C 3 3 0 0 U s e r M a n u a l
N E T W O R K P O R T O P T I O N
Set:
netpass
Chassis response:
System prompts user for the password.
Factory default setting:
endrun_1
netprotocol
This command sets or queries for the protocol used for accessing the network port. Choices are either
Telnet or SSH. Syntax is: netprotocol=x, where x is either Telnet or SSH.
Set:
netprotocol=ssh
Chassis response:
OK
Query:
netprotocol
Chassis response:
ssh
Factory default setting:
telnet
netreset
This command will reset the network port. This is needed after the network parameters are changed.
For example, if you change from DHCP on to off then you will need to reset the network port.
Command:
netreset
Chassis response:
Resetting network port.......
netsnmp
This command enables or disables SNMP. Syntax is: netsnmp = x where x is on or off.
Set:
netsnmp=on
Chassis response:
OK
Query:
netsnmp
Chassis response:
on
Factory default setting:
off
netsnmpro
This command sets the SNMP read-only community string. The community string must be at least 8
and less than 32 characters. Characters must be alphanumeric or the underscore ‘_’. Entering con-
trol-C will quit without changing the community string. There is no query mode for this command.
Set:
netsnmpro
Chassis response:
System prompts for the SNMP read-only community string.
Factory default setting:
fdc_user
Summary of Contents for FDC3300
