4 Installation
WirelessHART Adapter SWA70
20
Hauser
4.4
Mounting on the field device
You require the following tools to mount the WirelessHART Adapter on the field device:
• Wrench 24 mm across flats (SW 24)
• Wrench 42 mm across flats (SW 42)
Fig. 4-3: Mounting on the device
Note!
• By loosening the fixing nut you can rotate the cable entry without having to turn the housing of
the WirelessHART Adapter.
Proceed as follows to mount the WirelessHART Adapter on the field device:
1. Remove the sealing cap on the cable entry.
2. Fit a seal on either side of the double-threaded connection adapter as far as the end of the
thread.
3. Using the 24 mm wrench, screw the connection adapter into the field device coupling
(torque 5 Nm).
4. Release the fixing nut of the WirelessHART Adapter.
5. Fit the cable entry of the WirelessHART Adapter onto the connection adapter screwed into the
field device and tighten the cable entry using the 24 mm wrench (torque 5 Nm).
1
Double-threaded connection adapter
2
Fixing nut
3
Cable entry
loosen
tighten
loosen
tighten
1
2
3
