Endress+Hauser SpectraSensors SS2000e, Operator'S Manual

Page: 15 / 114

Operator’s Manual 2
–
1
2 - O
PERATING THE
A
NALYZER
Firmware Version
Each SpectraSensors analyzer operates with a specific version of firmware. The
firmware version for each analyzer is listed in the associated system calibration
report, and displays upon start up of the analyzer. The operation instructions
provided in this chapter are intended for the NS 5.14 firmware version.
Powering Up the Analyzer
After mounting the analyzer, connecting the power wires, connecting the gas
lines, connecting the (optional) output signal wires and checking for leaks, you
are ready to power up the analyzer.
To power up the analyzer
1. Power up the analyzer by energizing the circuit to the analyzer.
2. For systems with a heated enclosure, confirm that the sample
system enclosure is heated to approximately the specified
temperature by observing the temperature reading on the door
mounted thermometer.
The analyzer is designed to be a stationary measuring device. It
should be securely mounted during normal operation.
The laser housing labels on the flanges of the sample cell warn
about exposure to laser radiation inside. Never open the sample
cell unless directed to do so by Service and the analyzer power is
turned off. Refer to “Service Contact” on page A-4
The optical head has a seal and “WARNING” sticker to prevent
inadvertent tampering with the device. Do not attempt to
compromise the seal of the optical head assembly. Doing so will
result in loss of device sensitivity and inaccurate measurement
data. Repairs can then only be performed by the factory and are
not covered under warranty.
Refer to the figures for the analyzer electronic control boards in
the Hardware Manual for fuse location. If you need to replace a
fuse, use only the same type and rating of fuse as the original as
listed in the analyzer fuse specifications table in the Hardware
Manual.