Endress+Hauser Solitrend MMP40, Operating Instructions Manual

Page: 14 / 36

Installation Solitrend MMP40
14 Hauser
5.5.1 Mounting flange Ø55 mm
The mounting flange for the rod sensor can be mounted on the container wall.
48 (1.89)
80 (3.15)
Ø55 (2
.17)
10
(0.39)
Ø7
(0.28)
48 (1.89)
1
A0038247
 7 Mounting flange for the rod sensor
The mounting flange serves as a template for the mounting bore holes and the cut-out for
the sensor in the container:
1. Check the fit between the sensor and mounting flange
 An installation pipe must first be mounted on the sensor before the mounting
flange can be fixed. The installation pipe is available in two different lengths and
can be ordered together with the device via the "Accessory mounted" (option NA)
or "Accessory enclosed" (option PA) section of the product order structure.
2. Make the cut-out in the container
5.6 Protection of sensor connector against abrasion
If sand and gravel can come into contact with the sensor connector when they flow over
the baffle plate, it is recommended to mount an additional protective guard on the sensor
connector.
1. The heat-shrink tube supplied with the cable can be used to provide this protection.

A0037427
 8 Example of round sensor