Basic safety instructions
Smart System for Aquacultures SSP200B
8
Hauser
2
Basic safety instructions
2.1
Requirements for personnel
The personnel for installation, commissioning, diagnostics and maintenance must meet
the following requirements:
‣
Trained, qualified specialists: must have a relevant qualification for this specific role
and task and have been trained by Hauser. Experts at the Hauser
service organization.
‣
Personnel must be authorized by the plant owner/operator.
‣
Personnel must be familiar with regional and national regulations.
‣
Before starting work: personnel must read and understand the instructions in the
manual and supplementary documentation as well as the certificates (depending on
the application).
‣
Personnel must follow instructions and comply with general policies.
Operating personnel must meet the following requirements:
‣
Personnel are instructed and authorized according to the requirements of the task by
the facility's owner-operator.
‣
Personnel follow the instructions in this manual.
2.2
Designated use
The Smart System SSP200B for freshwater applications is designed to monitor freshwater.
The Smart System SSP200B for salt water applications is designed to monitor salt water.
The Liquiline CM444 transmitter is a multichannel controller and is used to connect the
digital sensors supplied.
Any other use is considered to be non-designated use. Designated use entails compliance
with the operating and maintenance requirements specified by the manufacturer. The
Smart System must be mounted in an environment intended for this purpose.
The Smart System is not suitable for use in explosive atmospheres.
Dangers
It is the responsibility of the owner/operator to assess any dangers for the systems.
These dangers must be assessed by the owner/operator and the measures resulting
from the assessment must be implemented. While the Smart System can form part of
such a measure, responsibility for the process always rests with the owner/operator,
particularly the taking of suitable measures if the Smart System signals an alarm.
Incorrect use
Non-designated use can compromise safety. The manufacturer is not liable for
damage caused by improper or non-designated use.
2.3
Occupational safety
Personnel must meet the following conditions when working on and with the system:
‣
Wear the required personal protective equipment according to regional/national
regulations.
‣
When welding, do not ground the welding unit via the system.
‣
If hands are wet, wear gloves on account of the higher risk of electric shock.
2.4
Operational safety
Operate the system only if it is in proper technical condition, free from errors and faults.
