Graphic Data Manager
Error messages and troubleshooting
29
Description of the barcodes in the Appendix:
"
Caution!
Failsafe mode:
• If the relevant data are not read in within x seconds (x can be configured in the main menu under
"Expert -> System -> Barcode reader -> Timeout sequences", 10 to 180 s, default = 30 s) after
the command sequence is read in, the process is canceled without any messages.
• It is possible to read in a command sequence multiple, consecutive times. The last command
sequence read in is always the valid one.
3
Error messages and troubleshooting
Plain text on the screen of your device will keep you informed in the event of a fault or incorrect
input. If an error occurs in the device, the red LED lights up. The red LED flashes in the event of
warnings or if maintenance is required. If switched on in setup (standard = off), the red LED can
also optionally flash in the case of a set point alarm.
!
Note!
Refer to Section 9 of the Operating Instructions (see CD-ROM provided) for detailed instructions on
errors and solutions to problems.
4
Technical data
!
Note!
The technical data of the Operating Instructions on the CD-ROM supplied apply for this device
option.
Barcode
no.
Code
Function, description
m
START BATCH x
Start batch: scanning of the barcode starts the batch.
!
Note!
If user administration is activated, a user must be logged on so that a batch can be started.
n
STOPP BATCH x
Stop batch: scanning of the barcode ends the batch.
!
Note!
If user administration is activated, a user must be logged on so that a batch can be ended.
o
BATCH x ID
Identifier: after the barcode is scanned, the designation which identifies the batch can be scanned. Max. 30-digit.
p
BATCH x NAME
Batch name: after the barcode is scanned, the batch name which identifies the batch can be scanned. Max. 30-digit.
q
BATCH x NO
Batch number: after the barcode is scanned, the batch number can be scanned. Max. 30-digit.
Can also be generated by the device as an option. An automaticlly generated batch number has 9 digits max., is
numerical and does not have a leading sign.
!
Note!
The function depends on the settings in "Setup -> Application -> Batch mode -> Batch number".
r
BATCH x ENTER
ALL
After the barcode is scanned, the identifier, batch name and batch number can be scanned one after another. In this
way, individual scanning of barcode 3, 4 and 5 is not necessary.
s
BATCH x DEFAULT
Preset counter: after the barcode is scanned, the default value can be scanned. Max. 12-digit.
The batch is automatically ended when the counter value >= the default value.
t
CANCEL
Scanning of the barcode cancels barcode entry.
!
Note!
The batch is not canceled!
